• 2000 - 2002 Toyota Echo
    TR40P

    Price: $0.93

    SKU: MK-PH-TR40-P

    Plastic Head TR40P


    Programming

  • 2000 - 2002 Toyota Echo

    Price: $0.66

    SKU: JMA-KB-TR40


    Programming

  • 2000 - 2003 Toyota Echo
    BAB237131-056

    Price: $40.50

    OE #: 08191-00922

    SKU: TOY-154 AM

     TOYOTA TVIP SYSTEM PROGRAMMING-RS3200

     ADD ADDITIONAL REMOTE CONTROL(S) TO SYSTEM

    Follow this procedure to add additional remote controls to a system. The RS3200 may be programmed to operate with a maximum of four remote controls. When a new remote controls is programmed, it will work in the default operation mode (press the UNLOCK button twice to unlock all doors and no AUX button function on  4 button remote controls); to change the operation mode, you must perform the separate REMOTE CONTROL FUNCTION SELECT procedure as shown on pages 6 and 7 of the manual.

     Before you begin:

    Open the driver s door and remove the key from the ignition switch.

    Start the programming procedure. (Complete these steps within 40 seconds.)

     

    1. Insert the key into, and remove it from the ignition switch 2 times.
    2. Close, then open the driver s door 2 times.
    3. Insert the key into, and remove it from the ignition switch 1 time.
    4. Close, then open the driver s door 2 times.
    5. Insert the key into, the ignition switch and leave it in.
    6. Close the driver s door.
    7. Turn the key from LOCK to ON, then back to LOCK.
    8. Remove the key from the ignition switch.
    9. The tail and marker lights flash 1 time, the buzzer chirps 1 time and the doors lock

    and unlock 1 time.*

    * If the system does not activate the lights, buzzer and door locks 1 time, start over.

     Program (add) an additional remote control.

     

    1. Press and release both the LOCK and UNLOCK buttons control at the same time.
    2. Press and release the LOCK button.
    3. The tail and marker lights flash 1 time, the buzzer chirps 1 time, and the doors lock

    and unlock 1 time.*

     Note: Repeat the above steps to add additional remote controls.

     To end programming open the driver s door

     

     

    DEALER INSTALLED - PLEASE VERIFY!

     

     


    Programming